Knitted Paint Tube
The concept of a "Knitted Paint Tube" combines the cozy charm of knitting with the vibrant world of art. Picture a traditional paint tube transformed into a soft, squishy masterpiece, ready to brighten up any craft corner or artist's studio. This whimsical creation not only adds a touch of creativity to the mundane, but it also serves as a delightful conversation starter for crafting enthusiasts. Imagine the satisfaction of squeezing a colorful yarn-filled tube instead of the usual rigid container! With its unique blend of texture and functionality, the Knitted Paint Tube brings a colorful twist to the world of arts and crafts, making it a must-have for anyone looking to inject a bit of fun into their creative endeavors.
You will need:
- coloured yarn (4 ply)
- snap fastener (optional)
- 4 x double ended knitting needles (2.75mm)
- tapestry needle
- scissors
Pattern:
Nozzle
Cast on 30 sts in grey and join into the round.
- Rounds 1 and 2: k –
- Round 3: [k2tog, k3] x 6 (24)
- Round 4: k –
- Round 5: [k2tog, k2] x 6 (18)
- Round 6: k –
- Round 7: [k2tog, k1] x 6 (12)
- Round 8: k –
- Rounds 9 to 12: p –
- Rounds 13 to 18: k –
Cast off.
Tube
- Using grey yarn pick up 30 sts along the cast on edge of the nozzle.
- Knit around 1cm in the round.
- Change to coloured yarn and knit a further 5cm.
- Change back to grey yarn and knit 3cm more or until the tube is 9cm long in total.
Paint
- Using coloured yarn cast on 4 stitches.
- Work 30 cm i-cord.
- Cut yarn, thread through remaining stitches and pull tight.
Making Up:
Turn the tube and nozzle inside out. Fold the end of the nozzle over on itself to get a double thickness of knitting. Sew into place, then sew in any remaining loose ends on the inside of the tube, then turn the right way out again.
If your paint tube is going to be used mostly for display flatten the end of the tube and sew the edges together to form a neat seam. Poke the i-cord paint through the open nozzle (a twisting motion helps with this), but always leave the end sticking out as it's the devil to get out otherwise.
If your paint tube is going to be played with a lot then it is easier to leave the end of the tube open so you can insert the i-cord paint that way. Attach a snap fastener to the inside edge of the paint tube to hold it closed.